1、仿古门窗装入洞口应横平竖直，外框与洞口应弹性连接牢固，不得将门外框直接埋入墙体。

1, antique doors into the cave should be vertical and horizontal, and the elastic frame shall be firmly connected, the door frame may not be directly buried in the wall.

2、木材应选用一、二等红白松或材质相似的木材，夹板门的面板采用五层优质胶合板或中密度纤维板。油漆应采用聚酯漆，使用耐水、无毒型胶粘剂。

2, one or two red and white pine wood should be used or similar material of wood, plywood door panel adopts five layers of plywood or mdf. Paint should use polyester paint, the use of water, non-toxic adhesive.

3、仿古门窗应采用塑料胶带粘贴保护，分类侧放，防止受力变形。

3, antique doors and windows should be protected with plastic tape, the classification of the side, to prevent the deformation of the force.

4、防腐处理：若设计无要求时，门侧边、底部顶部与墙体连接部位可涂刷如橡胶型防腐涂料或涂刷聚丙乙烯树脂保护装饰膜。

4, anti-corrosion treatment: if there is no design requirement, side edge and the bottom of the top wall and connecting parts such as rubber brush type anticorrosion coating or coating polystyrene resin protective decorative film.

5、大于1.5平方米的玻璃门应采用厚度5mm的安全玻璃，宽度大于1m 的仿古建筑门窗，合页应按"上二下一"的要求安装，中间合页的位置应处于仿古门窗框高度的2/3处。合页安装前，门框与门扇应双面开槽，注意合页的安装方向。

5, more than 1.5 square meters of glass doors should be safety glass with thickness of 5mm, width of more than 1m of the antique building doors and windows, the hinge installation shall be in accordance with "two" requirements, the middle hinge position should be in the window frame at the height of the antique 2/3. Before the installation of the hinge, door frame and the door leaf should be double slotted, pay attention to the installation direction of the hinge.